Brocade Fabric OS Command Reference Manual - Supporting Fabric OS v5.3.0 (53-1000436-01, June 2007)

30 Fabric OS Command Reference Manual
53-1000436-01
agtCfgShow
2
Trap Recipient Severity Level
The trap severity level is associated with each trap recipient IP address. The event trap level is in
conjunction with the event's severity level. When an event occurs and if its severity level is at or
below the set value, the SNMP event trap, swEventTrap, is sent to configured trap recipients. By
default, this value is set to 0, implying that no swEventTrap is sent. Possible values are:
0none
1critical
2error
3 warning
4 informational
5debug
Refer to errShow for related information.
The ACL check is as follows: there are six ACLs to restrict SNMP get/set/trap operations to hosts
under a host-subnet-area. Host-subnet-area is defined by comparing nonzero IP octets. For
example, an ACL of 192.168.64.0 enables access by any hosts that start with the specified octets.
The connecting host is enabled to set each host-subnet-area to be read-write or read-only. The
highest privilege matched out of six entries is given to the access. The ACL check is turned off when
all six entries contain 0.0.0.0. The default values of all six entries are 0.0.0.0.
When secure mode is enabled, the access control list feature is incorporated into the WSNMP and
RSNMP security policies. Community strings can be changed on the primary FCS switch only and
will propagate changes across the fabric.
Operands none
Examples To display SNMP agent configuration information:
switch:admin> agtcfgshow
sysDescr = Fibre Channel Switch.
sysLocation = End User Premise.
sysContact = Field Support.
authTraps = 0 (OFF)
SNMPv1 community and trap recipient configuration:
Community 1: Secret C0de (rw)
Trap recipient: 10.32.147.113
Trap recipient Severity Level: 0
Community 2: OrigEquipMfr (rw)
Trap recipient: 1080::8:800:200C:1234
Trap recipient Severity Level: 0
Community 3: private (rw)
No trap recipient configured yet
Community 4: public (ro)
No trap recipient configured yet
Community 5: common (ro)
No trap recipient configured yet
Community 6: FibreChannel (ro)
No trap recipient configured yet
SNMP access list configuration:
Entry 0: Access host subnet area 10.32.147.255 (rw)