Brocade Fabric OS Command Reference Manual - Supporting Fabric OS v5.3.0 (53-1000436-01, June 2007)

Fabric OS Command Reference Manual 749
53-1000436-01
Chapter
4
Exclusive Primary FCS Commands
This chapter summarizes the commands that are available only on the primary FCS when security
mode is enabled.
Commands Exclusive to the Primary FCS
The following commands are available only on the primary FCS when security mode is enabled.
TABLE 1 Commands Exclusive to the Primary FCS
Command Notes
agtCfgDefault Must be run from the primary FCS switch.
agtCfgSet Can be run on all switches, but it needs to be run on the primary FCS to modify
community strings
agtCfgShow Can be run on all switches, but it needs to be run on the primary FCS to show
community strings
aliAdd Must be run from the primary FCS switch.
aliCreate Must be run from the primary FCS switch.
aliDelete Must be run from the primary FCS switch.
aliRemove Must be run from the primary FCS switch.
aliShow Must be run from the primary FCS switch.
cfgAdd Must be run from the primary FCS switch.
cfgClear Must be run from the primary FCS switch.
cfgCreate Must be run from the primary FCS switch.
cfgDelete Must be run from the primary FCS switch.
cfgDisable Must be run from the primary FCS switch.
cfgEnable Must be run from the primary FCS switch.
cfgRemove Must be run from the primary FCS switch.
cfgSave Must be run from the primary FCS switch.
cfgShow Can be run on all FCS switches.
cfgSize Must be run from the primary FCS switch.
cfgTransAbort Must be run from the primary FCS switch.
cfgTransShow Must be run from the primary FCS switch.