Brocade Fabric OS Documentation Addendum - Supporting Fabric OS v5.2.x (53-1000429-01-HP)

1-36 Fabric OS Documentation Addendum

Publication Number: 53-1000429-01-HP

portCfgShow Note: Enter commands in lowercase only; mixed case is for readability

RSCN Suppression Displays as ON when the port has RSCN suppression enabled or blank (..) when

the port has RSCN suppression disabled. This value is set by the portCfg

rscnsupr command.

Persistent Disable Displays as ON when the port is persistently disabled. This value is set by the

portCfgPersistentDisable command.

Mirror Port Mode Displays as ON when the port has Mirror Port Mode enabled or blank (..) when

the port has the Mirror Port Mode disabled. This value is set by the portCfg

mirrorport command.

NPIV capability Displays as ON when the port has N_Port ID Virtualization (NPIV) enabled or

blank (..) when the port has the NPIV capability disabled. This value is set by the

portCfgNPIVPort command. It is enabled by default for Condor-based ports and

disabled by default for Bloom-based ports.

Note

The execution of this command is subject to Admin Domain restrictions that may be in place.

Operands This command has the following operands:

arp Displays address resolution protocol (ARP) table.

fciptunnel Displays FCIP tunnels on this GbE port. Possible optional args include: all, which

displays all FCIP tunnels; tunnel_id, which displays the specified FCIP tunnel; -

ipsec, which displays IKE and IPSec policy information on IPSec-enabled

tunnels.

ipif Displays the IP interface.

iproute Displays the IP route.

mode Displays mode of a GbE port.

slotnumber For bladed systems only, specifies the slot number of the port to display, followed

by a slash (/).

portnumber Specifies the port number to display, relative to its slot for bladed systems. Use

switchShow to display a list of valid ports. This operand is optional; if omitted,

this command displays information for all ports.