Brocade Fabric OS Documentation Addendum - Supporting Fabric OS v5.2.x (53-1000429-01-HP)

1-42 Fabric OS Documentation Addendum
Publication Number: 53-1000429-01-HP
portshow Note: Enter commands in lowercase only; mixed case is for readability
1
Note
The execution of this command is subject to Admin Domain restrictions that may be in place.
Operands This command has the following operands:
arp Displays ARP table. Use this operand to display IP addresses, corresponding
MAC addresses, and flags.
fciptunnel Displays FCIP tunnel IDs, remote and local IP addresses, remote and local
WWNs, compression status, FCIP fastwrite state for the tunnel endpoint, Tape
Pipelining status, Uncommitted bandwidth rate, SACK status, Minimum
Retransmit time, Keepalive Timeout, Maximum Retransmissions, tunnel status,
tunnel uptime. You must specify all to display all FCIP tunnels or tunnel_id to
display the specified FCIP tunnel. Additional options include:
-perf Displays additional performance information.
-params Displays connection parameter information.
-ipsec Displays IKE and IPSec policy information on IPSec-enabled tunnels.
ipif Displays the IP interface, IP address, netmask, and MTU.
iproute Displays the IP address, mask, gateway, metrics, and flags.
iscsi Displays GbE port WWN and iSCSI Sessions.
mode Displays the mode of the GbE port.
slot For bladed systems only, specify the slot number of the port to be configured,
followed by a slash (/).
[ge]port Specify the port number to be displayed, relative to its slot for bladed systems. See
switchShow for a list of valid ports.