Brocade Fabric OS Documentation Addendum - Supporting Fabric OS v5.2.x (53-1000429-01-HP)

2-2 Fabric OS Documentation Addendum

Publication Number: 53-1000429-01-HP

Updates to the Introduction Chapter

Add the following row to the System Modules Descriptions tabe on page 1-15.

New Chapter, AG System Messages

Add a new chapter titled AG System Messages after the Introduction and before the AUTH System

Messages; it contains all the new messages for the feature, Brocade Access Gateway mode.

AG-1001

Message

Probable

Cause

Indicates that the fabric port to which Access Gateway is connected does not support NPIV.

Recommended

Action

Enable NPIV on the port connected to the Access Gateway using the portCfgNpivPort command on

the fabric switch. Refer Fabric OS Command Reference Manual for more information on this

command.

Severity ERROR

AG-1002

Message

Probable

Cause

Indicates that the F_Ports could not be failed over because no other N_Ports are configured or that the

fabric was unstable during the failover attempt.

Recommended

Action

Verify whether or not other N_Ports are configured.

If the message persists, run supportFtp to set up automatic FTP transfers; then run the supportSave

command and contact your switch service provider.

Severity WA RNI NG

AG Access Gateway mode messages of the Fabric OS.

<timestamp>, [AG-1001], <sequence-number>,, ERROR, <system-name>,

N_Port <port> is connected to a fabric port that does not support NPIV

<timestamp>, [AG-1002], <sequence-number>,, WARNING, <system-name>,

Unable to find alternate N_Port during fail over for N_Port <port>