Brocade Fabric Watch Administrator's Guide (53-1000243-01, November 2006)

1-22 Fabric Watch Administrator’s Guide
Publication Number: 53-1000243-01
Notification Methods
1
E-mail Alert
E-mail alert sends information about a switch event to a specified e-mail address. E-mail alert can send
information about any error from any element, area, and class.
The e-mail specifies the threshold and describes the event, much like an error message. Use the
fwMailCfg command to configure e-mail alerts.
Assigning Notification Methods
Specify the particular notification method that you want Fabric Watch to use by assigning it a value.
Table 1-10 shows the numerical values for each notification method.
To determine the value for the event setting attribute that enables all desired notification methods, add
the values assigned to each method. For example, to enable SNMP trap, Rapi Trap and e-mail
notification, use the value 22, which is equal to the sum of 2, 4, and 16.
Not all notification methods are valid for all areas. Every area has an associated valid alarm matrix,
which is the sum of all valid notification methods for that area. For example, an area with a valid alarm
matrix of 25 allows the error log entry (1), port log lock (8) and e-mail notification (16) methods, but
does not allow the SNMP trap (2) or Rapi Trap (4) methods.
An area with a valid alarm matrix of 31 allows all of the notification types.
N
ote
To send e-mail alerts, the switch must be connected to a DNS server. Use the dnsConfig command to
configure DNS settings.
Also, enabling E-mail alerts for the Changed threshold state in several areas can quickly result in a
significant amount of E-mail. Fabric Watch discards E-mail alerts when more than 100 are generated
within a minute; this prevents memory shortages.
Table 1-10 Numerical Values of Notification Methods
Notification Method Assigned Value
Error log entry 1
SNMP trap 2
Rapi Trap 4
Port log lock 8
E-mail notification 16