Fabric OS Encryption Administrator's Guide v6.4.0 (53-1001864-01, June 2010)

200 Fabric OS Encryption Administrator’s Guide
53-1001864-01
Management application encryption wizard troubleshooting
6
Management application encryption wizard troubleshooting
•Errors related to adding a switch to an existing group . . . . . . . . . . . . . . . . 200
•Errors related to adding a switch to a new group . . . . . . . . . . . . . . . . . . . . 201
•General errors related to the Configure Switch Encryption wizard . . . . . . 203
Errors related to adding a switch to an existing group
Table 11 lists configuration task errors you might encounter while adding a switch to an existing
group, and describes how to troubleshoot them.
TABLE 11 Error recovery instructions for adding a switch to an existing group
Configuration task Error description Instructions
Initialize the switch Unable to add switch to encryption
group. The switch is no longer a group
leader or does not contain a group.
Manual option:
To add a switch to the group on the leader switch:
1 Re-launch the Configure Switch Encryption wizard
and create a new encryption group on the leader
switch.
2 When that group is created, launch the Configure
Switch Encryption wizard again and add the switch to
the group.
Initialize the switch The switch was not properly initialized
and was aborted because it is
unavailable.
Re-run the Configure Switch Encryption wizard for the
switch.
Add the switch to the encryption
group
Adding the switch to the encryption
group failed.
Re-run the Configure Switch Encryption wizard for the
switch.
Enable the encryption engines A failure occurred while attempting to
enable encryption engines on the
switch.
1 Remove the switch from the group using the Group
Members tab on the Encryption Group Properties
dialog box.
2Re-run the Configure Switch Encryption wizard for
the switch.
Manual Option:
1 Save the switch’s public key certificate to a file using
the Switch Encryption Properties dialog box.
2 Follow the Key Vault instructions for
RSA/Decru/Other key vault.
Save the switch’s public key
certificate to a file.
The switch’s public key certificate could
not be saved to a file.
Note: Verify that the path name and the
file name that you are using are both
valid and that you have write
permissions for the file.
1 Remove the switch from the group using the Group
Members tab on the Encryption Group Properties
dialog box.
2Re-run the Configure Switch Encryption wizard for
the switch.
Manual Option:
1 Save the switch’s public key certificate to a file using
the Switch Encryption Properties dialog box.
2 Follow the Key Vault instructions.