Fabric OS Encryption Administrator's Guide v6.4.0 (53-1001864-01, June 2010)

58 Fabric OS Encryption Administrator’s Guide
53-1001864-01
Adding target disk LUNs for encryption
2
5. Click Next.
The Select Initiator Port dialog box displays.
6. Select the initiator port from the Initiator Port list.
7. Cl ic k Next.
LUN discovery is launched, and a progress bar displays. There are four possible outcomes:
- A message displays indicating No LUNs are discovered. Click OK to dismiss the message
and exit the wizard.
- A message displays indicating LUNs are discovered, but are already configured. Click OK to
dismiss the message and exit the wizard.
- A message displays indicating that the target is not in the right state for discovering LUNs.
Click OK to dismiss the message and exit the wizard.
- The Select LUN dialog box displays, showing discovered LUNs that are available.
8. Select the LUN from LUN list.
9. Click Finish.
The new LUN path is added to the Encryption Disk LUN view.
10. In environments where there are multiple paths to the same LUNs, it is critical that the same
LUN policies are configured on all instances of the LUN. Be sure to return to the Encryption
Disk LUN view to determine of there are configuration mismatches. Check under Encryption
Mode for any entries showing Mismatch. You can correct the mismatch by clicking on the
incorrect mode to display the choices, and selecting the correct mode (Figure 37).
FIGURE 37 Correcting an Encryption Mode Mismatch
When you correct a policy on a LUN, it is automatically selected for all paths to the selected
LUN. When you modify LUN policies, a Modify icon appears to identify the modified LUN entry.
11. Click Add or Apply to apply the modifications.