Brocade Fabric OS Troubleshooting and Diagnostics Guide v6.2.0 (53-1001187-01, April 2009)

Fabric OS Troubleshooting and Diagnostics Guide 45
53-1001187-01
Firmware download issues
5
The server is inaccessible or firmware path is invalid. Please make sure the
server name or IP address, the user/password and the firmware path are valid.
Symptom Cannot download the requested firmware.
Probable cause and recommended action
The firmware you are trying to download on the switch is incompatible. Check the firmware version
against the switch type. If the firmware is incompatible, retrieve the correct firmware version and
try again.
Example of error message
SW3900:admin> firmwaredownload
Server Name or IP Address: 192.168.126.115
User Name: jdoe
File Name: /users/home/jdoe/firmware/v6.2.0
Network Protocol(1-auto-select, 2-FTP, 3-SCP) [1]: 2
Password: <hidden>
Server IP: 192.126.168.115, Protocol IPv4
Checking system settings for firmwaredownload...
Cannot download the requested firmware because the firmware doesn't support this
platform. Please enter another firmware path.
Symptom Cannot download on a switch with Interop mode turned on.
Probable cause and recommended action
On single CP, Interop fabric does not support Coordinated HotCode Load.
Perform a firmwareDownload -o command. The operand bypasses the checking of Coordinated
HotCode Load (HCL). On single CP systems in interop fabrics, the HCL protocol is used to ensure
data traffic is not disrupted during firmware upgrades. This option will allow a firmware download to
continue even if HCL is not supported in the fabric or the protocol fails. Using this option may cause
traffic disruption for some switches in the fabric.
Symptom You receive a firmwaredownload is already in progress message.
Probable cause and recommended action
The firmware download process has already been started and it is in progress. Wait till it
completes. You can use the firmwareDownloadStatus and firmwareShow commands to monitor its
progress. If you are sure there is no firmware download in progress and the error still shows up, you
can reboot the switch to remedy it. If the problem persists, contact your switch support provider.
Example of a firmwaredownload already in progress
switch:admin> firmwaredownload
Server Name or IP Address: 192.126.168.115
User Name: jdoe
File Name: /users/home/jdoe/firmware/v6.2.0
Network Protocol(1-auto-select, 2-FTP, 3-SCP) [1]: 2
Password:
Server IP: 192.126.168.115, Protocol IPv4
Checking system settings for firmwaredownload...
Sanity check failed because firmwaredownload is already in progress.