HP StorageWorks Fabric OS 6.1.1 administrator guide (5697-0235, December 2009)

ManualsBrandsHP ManualsStorageHP StorageWorks 4/32B SAN Switch

301

302

303

304

305

306

307

308

309

310

304 Optimizing fabric behavior

c. Issue the following commands to reactivate your current effective configuration and enforce the TI

zones.

E1switch:admin> cfgactvshow

Effective configuration:

cfg: cfg_TI

zone: lsan_t_i_TI_Zone1

10:00:00:00:00:00:02:00:00

10:00:00:00:00:00:03:00:00

10:00:00:00:00:00:08:00:00

E1switch:admin> cfgenable cfg_TI

You are about to enable a new zoning configuration.

This action will replace the old zoning configuration with the

current configuration selected.

Do you want to enable 'cfg_TI' configuration (yes, y, no, n): [no] y

zone config "cfg_TI" is in effect

Updating flash ...

3. Log in to the edge fabric 2 and set up the TI zone.

a. Issue the fabricShow command to display the switches in the fabric. From the output, you can

determine the front and translate domains.

E2switch:admin> fabricshow

Switch ID Worldwide Name Enet IP Addr FC IP Addr Name

-------------------------------------------------------------------------

1: fffc01 50:00:51:e3:95:36:7e:09 0.0.0.0 0.0.0.0 "fcr_fd_1"

4: fffc04 50:00:51:e3:95:48:9f:a1 0.0.0.0 0.0.0.0 "fcr_xd_6_9"

9: fffc09 10:00:00:05:1e:40:f0:7d 10.32.72.9 0.0.0.0 >"E2switch"

The Fabric has 3 switches

b. Issue the following commands to create and display a TI zone:

E2switch:admin> zone --create -t ti TI_Zone1 -p "9,2; 9,3; 9,6; 1,-1; 4,-1"

E2switch:admin> zone --show

Defined TI zone configuration:

TI Zone Name: TI_Zone1

Port List: 9,2; 9,3; 9,6; 1,-1; 4,-1

Status: Activated Failover: Enabled