HP StorageWorks Fabric OS 6.1.1 administrator guide (5697-0235, December 2009)

Fabric OS 6.1.x administrator guide 411
The following example shows two FCIP tunnels created on slot 8, port ge0; the first with an uncommitted
bandwidth (0), and the second with a committed bandwidth of 10000
Kb/sec:
The following example shows an FCIP tunnel created between a remote interface 10.1.1.44, and a local IP
i n t e r f a c e 192.168 .131.124 :
Modifying and deleting QoS Settings
The QosMap option of the portCfg fciptunnel command allows you to modify QoS settings or
delete the QosMap configuration file for a virtual port without bringing the FCIP tunnel down.
1. Connect to the switch and log in using an account assigned to the admin role.
2. Issue the portCfg fcipTunnel command to modify QoS settings on a virtual port. You must specify
at least one characteristic to modify:
portCfg fciptunnel [Slot/]ge0|ge1 qosmap tunnel_id -default -delete -Q data-dscp
-P L2cos
where:
• tunnel_id is in the range 0-7
• --default resets or sets the virtual channel QoS map to default values
• --delete deletes the associated QoS map configuration file. Delete QoS mappings before
downgrading to pre-6.0.0 firmware versions that do not support QoS mapping. It removes the file
from the config flash memory only. The file is automatically reset to defaults if later used or
modified.
NOTE: Modified values are not reset to defaults when the tunnel QoS is disabled and enabled. If you
want to revert to default values, use the -default option.
Deleting an FCIP tunnel
1. Connect to the switch and log in using an account assigned to the admin role.
2. Issue the portCfg fciptunnel command to delete FCIP tunnels:
portcfg fciptunnel [slot/]ge0|ge1 delete tunnel_id
The following example shows two tunnels deleted on slot 8, port ge0:
switch:admin06> portcfg fciptunnel 8/ge0 delete 6
switch:admin06> portcfg fciptunnel 8/ge0 delete 7
switch:admin06> portcfg fciptunnel 8/ge0 create 2 192.168.100.50
192.168.100.40 0
switch:admin06> portcfg fciptunnel 8/ge0 create 3 192.168.100.51
192.168.100.41 10000
switch:admin06> portcfg fciptunnel 3/ge0 create 6 10.1.1.44
192.168.131.124 155000
-default resets or sets the virtual channel QoS map to default values.
-delete deletes the associated QoS map configuration file. The -delete
option is used before firmware downgrades to versions previous to
Version 6.0.0 that do not support QoS mapping. It removes the
file from the config flash memory only. The file is automatically
created to defaults if later used or modified.
-Q data-dscp modifies the Diffserv marking value.
-P data-L2coS modifies the L2 Class of Service tagging value.