HP StorageWorks Fabric OS 6.1.1 administrator guide (5697-0235, December 2009)

436 FICON fabrics
FICON CUP license considerations
If fmsmode is enabled when the FICON CUP license is removed, the control device is reset. PDCM
enforcement continues. If fmsmode is disabled when the FICON CUP license is removed, no special action
is taken.
If fmsmode is enabled on a switch that does not have a FICON CUP license and then the license is
installed, you must first disable and then reenable fmsmode. If fmsmode is disabled and a FICON CUP
license is installed, no special action is required.
Zoning and PDCM considerations
The FICON Prohibit Dynamic Connectivity Mask (PDCM) controls whether or not communication between
a pair of ports in the switch is prohibited or allowed. If there are any differences in restrictions set up with
Advanced Zoning and PDCM, the most restrictive rules are automatically applied.
All FICON devices should be configured in a single zone using the Domain, Area notation. PDCM can
then be used to Allow or Prohibit access between specific port pairs.
PDCM persists across a failover because it is replicated at all times to the standby CP blade. The active
PDCM configuration is saved to the IPL if the ASM bit is set on.
Zoning and link incident reporting
Non-implicit link incidents (such as NOS recognized or bit error rate threshold exceeded) that are related
to a specific port are reported to registered listeners only if they are in the same zone as the port for which
the link incident is being reported. As long as all FICON devices are in a single zone, link incidents for
FICON ports are reported only to registered FICON listener ports.
The only exception to this is the loss of synchronization link incident. Even though this link incident is related
to a specific port, it can be reported to a registered listener that is in a different zone.
Implicit link incidents (such as WWN card failure or power supply failure) that are not related to a specific
port are reported to registered listeners regardless of zoning configuration.
FICON configuration files
The FICON file access facility is used to store configuration files. This includes IPL and other configuration
files. The Fabric OS saves the IPL and all other configuration files on the switch. A maximum of 16
configuration files, including the IPL file, are supported.
You can upload the configuration files saved on the switch to a management workstation using the
configUpload command. If the switch loses the configuration due to a hardware failure or filesystem
error, use the configDownload command to restore previously uploaded configuration files. Because
data uploaded using the configUpload command also contains the IPL, if Active=Saved mode is
enabled, the switch will ignore the IPL file downloaded with the configDownload command.
Uploading the configuration files
See ”Maintaining the switch configuration file” on page 145 for more information on the configUpload
command.
When you execute the configUpload command, all the files saved in the file access facility are
uploaded to a management workstation (there is a section in the uploaded configuration file labeled
FICON_CUP that exists in an encoded format).
Downloading configuration files with Active=Saved mode enabled
See ”Maintaining the switch configuration file” on page 145 for more information on the
configDownload command.
The contents of existing files saved on the switch, which are also present in the FICON_CUP section, are
overwritten.
The files in the FICON section of the configuration file, which are not currently on the switch, are saved on
the switch.