Brocade Fabric OS MIB Reference Guide v6.1.0 (53-1000602-02, June 2008)

2 Fabric OS MIB Reference
53-1000602-02
Understanding SNMP Basics
1
Understanding SNMP Basics
Every Brocade switch carries an agent and management information base (MIB), as shown in
Figure 1. The agent accesses information about a device and makes it available to an SNMP
network management station.
FIGURE 1 SNMP Structure
When active, the management station can get information or set information when it queries an
agent. SNMP commands, such as get, set, getnext, setnext, and getresponse, are sent from the
management station, and the agent replies once the value is obtained or modified ( Figure 2).
Agents use variables to report such data as the number of bytes and packets in and out of the
device, or the number of broadcast messages sent and received. These variables are also known
as managed objects. All managed objects are contained in the MIB.
FIGURE 2 SNMP Query
The management station can also receive traps, unsolicited messages from the switch agent if an
unusual event occurs. Refer to “Understanding SNMP Traps” on page 4 for more information.
FIGURE 3 SNMP Trap
The agent can receive queries from one or more management stations and can send traps to up to
six management stations.
Authentication and
Privacy [2]
(authPriv)
SNMPv1
SNMPv3
Not allowed.
Only SNMPv3 users with authPriv
privilege are allowed.
Not Sent.
Sent only for authPriv users.
No Access [3]SNMPv1
SNMPv3
Not allowed. Not Sent.
TABLE 1 Security Level Options (Continued)
security level Protocol Query Behavior Traps
Agent
Management Station
SNMP
MIB
Management Station
Agent
ge
t
, ge
t
nex
t
, se
t
reply
TRAP
Management Station
Agent