Brocade Fabric OS MIB Reference Guide v6.1.0 (53-1000602-02, June 2008)

Fabric OS MIB Reference 889

53-1000602-02

connUnitControl 1.3.6.1.3.94.1.6.1.22

Controls the addressed connUnit. Each implementation might choose not to allow any or all of

these values on a SET.

Cold start and warm start are as defined in MIB-II and are not meant to be a factory reset.

This is similar to swAdmStatus:

resetConnunitColdStart = reboot

resetConnunitWarmStart = fastboot

offlineConnUnit = disable switch

onlineConnUnit = enable switch

default after reboot = unknown

The declaration 1 (unknown) maps to the default value upon rebooting, and 2 (invalid) is not

applicable.

Declarations 3 and 4 perform the same operation—a cold boot of the switch.

Values Possible values are:

• unknown (1)

• invalid (2)

• resetConnUnitColdStart (3): Reboot. Performs a switch reboot.

• resetConnUnitWarmStart (4): Fastboot. The addressed unit performs a Warm Start reset.

• offlineConnUnit (5): Disable switch. The addressed unit puts itself into an

implementation-dependant offline state. In general, if a unit is in an offline state, it cannot be

used to perform meaningful Fibre Channel work.

• onlineConnUnit (6): Enable switch. The addressed unit puts itself into an

implementation-dependant online state. In general, if a unit is in an online state, it is capable

of performing meaningful Fibre Channel work.