Brocade Access Gateway Administrator's Guide - Supporting Fabric OS v5.2.1 (53-1000430-01)

Access Gateway Administrator’s Guide 4-3
Publication Number: 53-1000430-01
Determining the mapping and port status
4
To display an N_Port map
1. Connect and log in to the switch.
2. Enter the ag --mapshow command and specify the port number to display the N_Port failover and
failback policies and the mapped F_Ports.
Displaying the port status
This section explains how to determine the ports status.
N_Port Number of the port.
Failover Indicates whether or not the failover policy is enabled (1) or disabled
(0) on the N_Port.
Failback Indicates whether or not the failback policy is enabled (1) or disabled
(0) on the N_Port.
Current F_Ports Shows the F_Ports that are currently connected to the fabric on this
N_Port.
In the case of failover, the Current F_Port and Configured F_Ports
differ. For example (shown below), 8 failed over to this port from
another port.
Configured F_Ports Indicates the ports which are mapped to this N_Port.
switch:admin> ag --mapshow 0
N_Port : 0
Failover(1=enabled/0=disabled) : 1
Failback(1=enabled/0=disabled) : 1
Current F_Ports : 2;8;
Configured F_Ports : 2;