Brocade Fabric OS Command Reference Guide v6.1.0 (53-1000599-02, June 2008)

90 Fabric OS Command Reference
53-1000599-02
configure
2
configure
Changes system configuration settings.
Synopsis configure
Description Use this command to change the following system configuration settings for the switch:
• Switch fabric settings
• Virtual channel parameters
• F_Port login parameters
• Zoning operation parameters
• Remote State Change Notifications (RSCN) transmission mode
• Arbitrated Loop Parameters
• System Services Settings
• Portlog Events enable or disable Settings
• Secure Socket Layer (SSL) attributes
• Remote Procedure Call Daemon (RPCD) attributes
• cfgload attributes
• Webtools attributes
• System settings
Notes To access all parameters controlled by this command, you must disable the switch using the
switchDisable command. If executed on an enabled switch, only a subset of attribute can be
configured.
The Telnet interface is no longer configurable with this command. Use the ipFilter command to
enable or disable the Telnet interface.
The SNMP attributes are no longer configurable with this command. Use snmpConfig --set
seclevel to configure SNMP attributes.
The execution of this command is subject to Admin Domain restrictions that may be in place. Refer
to chapter 1, "Understanding Admin Domain Restrictions" and Appendix A, "Command Availability"
for details.
Operands none
The configure command runs in interactive mode and presents you with a series of hierarchical
menus. Each top-level menu and its associated submenus consist of a text prompt, a selection of
valid values, and a default value (in brackets).
The following keys control the execution of the command:
Return When entered at a prompt with no preceding input, the command accepts the
default value (if applicable) and moves to the next prompt.
Interrupt (Ctrl-C) Aborts the command immediately and ignores all changes made.
End-of-file (Ctrl-D) When entered at a prompt with no preceding input, terminates the command
and saves changes made.
The following parameters can be modified with the configure command: