Brocade Fabric OS Command Reference Guide v6.1.0 (53-1000599-02, June 2008)

124 Fabric OS Command Reference
53-1000599-02
errFilterSet
2
errFilterSet
Sets a filter for an error log destination.
Synopsis errfilterset [-d "destination"][-v "severity"]
Description Use this command to set a filter for an error log destination. A filter is set based on the severity level
of the messages.
If no parameters are specified, this command displays the filters that are currently in use.
Note The execution of this command is subject to Admin Domain restrictions that may be in place. Refer
to chapter 1, "Understanding Admin Domain Restrictions" and Appendix A, "Command Availability"
for details.
Operands This command has the following operands:
-d "destination" Specify the destination to set the filter. "console" is the only valid value at this
time.
-v "severity" Specify the minimum severity level of the message to pass through the filter.
Valid values are "INFO", "WARNING", "ERROR", or "CRITICAL".
Examples To display the current filter settings:
switch:admin> errfilterset
console: filter severity = WARNING
To set the filter severity level for the console:
switch:admin> errfilterset -d "console" -v "WARNING"
See Also errDump, errShow