Brocade Fabric OS Command Reference Guide v6.1.0 (53-1000599-02, June 2008)

Table Of Contents
166 Fabric OS Command Reference
53-1000599-02
fcrLsanCount
2
fcrLsanCount
Displays or sets the maximum LSAN count.
Synopsis fcrlsancount [max-lsan-count]
Description Use this command to set or display the maximum number of LSAN zones that can be configured on
the edge fabric. By default, the maximum LSAN count is set to 3000, which is also the minimum.
This command lets you create more LSANs on your edge fabric, up to 5000, if needed to support
additional devices. The maximum number of supported LSAN devices is 10,000.
When executed without operand, this command displays the current LSAN zone limit.
This command assumes that all FCRs in the same LSAN fabric matrix or backbone have the same
maximum LSAN count defined in order to protect the FCRs from running into indefinite state.
Asymmetric LSAN configurations due to different maximum LSAN counts may lead to different
devices being imported on different FCRs.
Since the maximum number of LSANs is configured per switch, if there is a different maximum
LSAN count on the switches throughout the meta-SAN, the device import or export will not be
identical on the FCRs. You should therefore enter the same maximum LSAN count for all the FCR
switches in the same backbone that support this feature. Verify the configured maximum limit
against the LSANs configured using the fcrResourceShow command.
Note The default LSAN count maximum of 3000 is the Fabric OS v5.2 default). It allows v5.2 to run on
the standby CP if the active CP runs firmware v5.3 or later. If this case, you cannot increase the
LSAN Zone count to 5000 and if the v5.2 standby CP is coming online in a system where the LSAN
count is set to 5000, the HA sync will not be established. In addition, downgrading to a firmware
version lower than v5.3 is blocked if LSAN count is set to 5000.
The execution of this command is subject to Admin Domain restrictions that may be in place. Refer
to chapter 1, "Understanding Admin Domain Restrictions" and Appendix A, "Command Availability"
for details.
Operands This command has the following operands:
max-lsan-count Specifies the maximum LSAN count.
Examples To display the current LSAN limit:
switch:admin> fcrlsancount
LSAN Zone Limit: 3000
To increase the LSAN zone limit:
switch:admin> fcrlsancount 5000
LSAN Zone Limit: 5000
See Also fcrResourceShow