Brocade Fabric OS Command Reference Guide v6.1.0 (53-1000599-02, June 2008)

220 Fabric OS Command Reference
53-1000599-02
fosConfig
2
fosConfig
Displays or modifies Fabric OS features.
Synopsis fosconfig --enable feature
fosconfig --disable feature
fosconfig --show
Description Use this command to enable or disable a feature, or to display the current operating status of
features on a switch.
The following features are supported (see Notes for limitations):
• FC Routing service (see fcrConfigure)
• iSCSI service (see iscsiCfg)
• iSNS client service (see isnscCfg)
Notes The features described may not be supported on all platforms. If you attempt to enable a feature
that is not supported on your platform, an error message stating "Command not supported on this
platform" is displayed.
The execution of this command is subject to Admin Domain restrictions that may be in place. Refer
to chapter 1, "Understanding Admin Domain Restrictions" and Appendix A, "Command Availability"
for details.
Operands This command has the following operands:
-enable feature
Enables a feature on the switch. This command can be run while the switch is
online. Valid values for feature are:
fcr Enables the FC Routing service on the switch. The FC Routing service is
disabled by default. Use fosConfig --show to determine if FCR is enabled or
disabled,
When enabling FCR, you may encounter one of the following system
messages:
"FC Routing service is in the process of being disabled, please try again after
a few minutes." This means that a command to disable the FC Routing
service is still in progress. Wait a few minutes and try again.
"FC Routing service is already enabled." This means that the FC Routing
service is already enabled.
iSCSI Enables the iSCSI service on the switch. By default, iSCSI is disabled.
iSNSC Enables the iSNSC service on the switch. By default, iSNSC is disabled.