Brocade Fabric OS Command Reference Guide v6.1.0 (53-1000599-02, June 2008)

Table Of Contents
Fabric OS Command Reference 221
53-1000599-02
fosConfig
2
--disable feature
Disables a feature on the switch. This command can be run while the switch
is online. Valid values for feature are:
fcr Disables the FC Routing service on the switch. All enabled EX_Ports and
VEX_Ports on the switch must be offline for this command to succeed. If
there is an XPath OS switch in the BB fabric, it may take up to eight minutes to
complete the disable process.
. To use this command to disable the FC Routing service only instead of
disabling the switch, issue this command, then change the BB fabric ID using
fcrConfigure.
When disabling the FCR service, you may encounter the following system
messages:
"Please disable all EX/VEX_Ports first before running this command." This
means that there were EX_Ports or VEX_Ports online when this command
was issued. Take these ports offline and try the command again.
"FC Routing service is already disabled" -This means that the FC Routing
service is already disabled.
iSCSI Disables the iSCSI service on the switch.
iSNSC Disables the iSNSC service on the switch.
--show Displays the current operating status of features on the switch.
Examples To display the status of the features:
switch:admin> fosconfig --show
FC Routing service: enabled
iSCSI service: enabled
iSNS Client service: disabled
To disable the FC Routing service:
switch:admin> fosconfig --disable fcr
FC Routing service is disabled
To enable the FC Routing service:
switch:admin> fosconfig --enable fcr
FC Routing service is enabled
To enable the iSCSI service:
switch:admin> fosconfig --enable iscsi
iSCSI service is enabled
To disable the iSCSI service:
switch:admin> fosconfig --disable iscsi
iSCSI service is disabled
See Also fcrConfigure, iscsiCfg, iscsiPortCfg, isnscCfg, switchShow