Brocade Fabric OS Command Reference Guide v6.1.0 (53-1000599-02, June 2008)

290 Fabric OS Command Reference
53-1000599-02
ipAddrSet
2
Examples To set the IPv4 addresses for switch number 1 on an enterprise-class system in interactive mode:
switch:admin> ipaddrset -sw 1
Ethernet IP Address [192.168.166.148]:
Ethernet Subnetmask [255.255.255.0]:
Fibre Channel IP Address [none]:
Fibre Channel Subnetmask [none]:
Committing configuration...Done.
OK.
To enable DHCP on a standalone, non-AP platform:
switch:admin> ipaddrset
Ethernet IP Address [192.168.74.102]:
Ethernet Subnetmask [255.255.255.0]:
Fibre Channel IP Address [220.220.220.2]:
Fibre Channel Subnetmask [255.255.0.0]:
Gateway IP Address [192.168.74.1]:
DHCP [Off]: on
To configure an IPv6 address and prefix on a standalone platform:
switch:admin> ipaddrset -ipv6 --add fec0:60:69bc:60:260:69ff:fed0:107/64
To configures an IPv6 address and prefix on an enterprise-class platform:
switch:admin> ipaddrset -cp 0 -ipv6 --add 1080::8:800:200C:417A/64
To delete any existing IPv6 address and prefix on CP 0 on an enterprise-class platform:
switch:admin> ipaddrset cp 0 -ipv6 --delete
To configure a local IPv4 Ethernet address on a Brocade FC4-16E in a chassis (prefix required):
switch:admin> ipaddrset -slot 1 -eth0 --add 10.12.34.123/24
To configure a local IPv4 Ethernet address on an AP7600 with a hidden BP:
switch:admin>ipaddrset -eth0 --add 10.12.34.123/24
See Also ipAddrShow