Brocade Fabric OS Command Reference Guide v6.1.0 (53-1000599-02, June 2008)

Fabric OS Command Reference 305
53-1000599-02
iscsiChipTest
2
iscsiChipTest
Performs functional test of components in iSCSI complex.
Synopsis iscsichiptest --slot slotnumber -testtype type -unit gbEports
Description Use this command to verify the memory of the network processor and iFlipper FPGA.
Note This command is supported only on the Brocade FR4-16IP blade. On all other platforms, this
command displays the message:
“Command not applicable to this platform. SKIPPED!”
The execution of this command is subject to Admin Domain restrictions that may be in place. Refer
to chapter 1, "Understanding Admin Domain Restrictions" and Appendix A, "Command Availability"
for details.
Operands This command has the following operands:
--slot slotnumber Specifies the slot number for which to run the diagnostics. The default is set
to 0 and designed to operate on fixed-port-count products.
-testtype type Selects the test type to run. By default, the command runs all tests. Valid
values are:
0 All of the following tests.
1 BCM 1125H SRAM test.
2 iFlipper internal register test.
-unit gbeports Specifies the GbE port to test. By default, all GbE ports in the specified slot
slotnumber are tested. Specify a value in the range of 0 - 7 or specify 8 for all
ports.
Examples To run iscsichiptest:
switch:admin> iscsichiptest --slot 7 -unit 1 -testtype 0
Running iscsichiptest ..............
Test Complete: iscsichiptest Pass 1 of 1
Duration 0 hr, 3 min & 12 sec (0:3:12:511).
passed.
See Also iscsiPathTest