Brocade Fabric OS Command Reference Guide v6.1.0 (53-1000599-02, June 2008)

430 Fabric OS Command Reference
53-1000599-02
portCfg
2
-n remote_wwn Specifies the remote-side FC entity WWN.
-q control-dscp Specifies the DSCP (DiffServ Code Point) Marking used for control TCP
connection of the FCIP tunnel. This operand is optional. Range is 0 to 63
(inclusive). Default value is 0.
-Q data-dscp Specifies the DSCP (DiffServ Code Point) Markingused for data TCP
connection of the FCIP tunnel. This operand is optional. Range is 0 to 63
(inclusive). Default value is 0.
-r retransmissions
Specifies the maximum retransmissions. Values are 1 to 16; default is 8.
If tape pipelining is enabled, the default value is calculated based on the
minimum retransmit time to ensure that the TCP connection does not
time out before the host times out. The specified value must be greater
than the calculated value.
-s Disables selective acknowledgement code (SACK) on the specified
tunnel.
-t Enable tape pipelining on the tunnel specified (requires fastwrite to be
turned on as well).
-ike policy Specifies the Internet Key Exchange (IKE) policy number to be used on
the specified tunnel. This option must be used together with -ipsec and
-key.
-ipsec policy Specifies the Internet Protocol security (IPSec) policy number to be used
on the specified tunnel. This option must be used together with -ike and
-key.
-key preshared-key
Specifies the preshared key to be used during IKE authentication. Specify
a double quoted string of alphanumeric characters between 12 and 32
bytes in length. This argument must be used together with -ike and
-ipsec.
NOTE: Only a single IPSec-enabled tunnel can be configured on a port. No
other tunnels (IPSec or otherwise) can be configured on the same port.
Jumbo frames are not supported on secure tunnels. Only a single route is
supported on an interface with a secure tunnel.
-v vlan_id Creates an FCIP tunnel with VLAN Tagging and Class of Service (CoS).
Specify a vlan_id in the range between 1 and 4094. There is no default. If
any other VLAN option is specified, this must also be specified.
The following operands are optional with VLAN tagging:
-p Control L2 CoS
Specifies the pL2_Class_of_Service/Priority, as defined by IEEE 802.1p,
for the FCIP control connection. Range is 0-7. Default is 0.
-P L2 CoS
Specifies the PL2 Class of Service/Priority, as defined by IEEE 802.1p, for
the FCIP data connection. Range is 0-7. Default is 0.