Brocade Fabric OS Command Reference Guide v6.1.0 (53-1000599-02, June 2008)

Fabric OS Command Reference 447
53-1000599-02
portCfgEXPort
2
-i mode Enables or disables Insistent Domain Id (IDID) for the specified EX_Port.
Specify 1 to enable IDID, specify 2 to disable IDID. This command must be
issued from a McDATA edge switch attached to a single or dual FCR
configuration.
Examples To set the fabric ID of port 2/1 to 5 and the port ID format to core:
switch:admin> portcfgexport 2/1 -f 5 -p 1
To configure port 2/0 to be an EX_Port and set the fabric ID to 4:
switch:admin> portcfgexport 2/0 -a 1 -f 4
To disable fabric parameter negotiation on port 2/0 of an EX_Port:
switch:admin> portcfgexport 2/0 -t 2
To enable IDID on port 2:
switch:admin>portcfgexport 2 –i 1
To display the configuration on port 2:
switch:admin> portcfgexport 2
Port 2 info
Admin: enabled
State: NOT OK
Pid format: Not Applicable
Operate mode: Open
Edge Fabric ID: 70
Preferred Domain ID: 109
Insistent Domain ID Mode: enabled
Front WWN: 50:00:51:e3:76:0e:4e:46
Fabric Parameters: Auto Negotiate
R_A_TOV: Not Applicable
E_D_TOV: Not Applicable
Authentication Type: None
DH Group: N/A
Hash Algorithm: N/A
Edge fabric's primary wwn: N/A
Edge fabric's version stamp: N/A
See Also portCfgVEXPort, portDisable, portEnable, portShow, portCfgDefault, fcrbCastConfig