Brocade Fabric OS Command Reference Guide v6.1.0 (53-1000599-02, June 2008)

Fabric OS Command Reference 525
53-1000599-02
portShow
2
ip_api_data_credit_target = 32
ip_api_data_credit_ratio = 80
ip_api_credit_time = 15
ip_api_cwnd_overcommit = 29760
FC control traffic TCP connection:
Local 10.10.9.100:4099, Remote 10.62.0.100:3225
Data transfer TCP connection:
Local 10.10.9.100:4100, Remote 10.62.0.100:3226
IKE Policy 1
IPSec Policy 1
Pre-Shared Key testingFIPSandIPSec
To display QoS Mappings:
switch:admin> portshow fciptunnel 9/ge0 0 -qosmap
Slot: 9 Port: ge0
-------------------------------------------
Tunnel ID 0
Remote IP Addr 10.62.0.100
Local IP Addr 10.10.9.100
Remote WWN Not Configured
Local WWN 10:00:00:05:1e:39:d4:5a
Compression on
Fastwrite on
Tape Pipelining on
Uncommitted bandwidth, minimum of 1000 Kbps (0.001000 Gbps)
SACK on
Min Retransmit Time 100
Keepalive Timeout 90
Max Retransmissions 9
VC QoS Mapping off
DSCP Marking (Control): 10, DSCP Marking (Data): 62
VLAN Tagging Id 1062, L2CoS (Control): 1, L2CoS (data): 0
Connected Count: 1
Uptime 2 hours, 14 minutes, 47 seconds
IKE Policy 1
IPSec Policy 1
Pre-Shared Key testingFIPSandIPSec
VC QoS Map:
VC DSCP L2CoS VC DSCP L2CoS VC DSCP L2CoS VC DSCP L2CoS
0 46 7 1 07 0 2 11 3 3 15 3
4 19 3 5 23 3 6 27 0 7 31 0
8 35 0 9 39 0 10 43 4 11 47 4
12 51 4 13 55 4 14 59 4 15 63 0
To display FICON EPCB for a GbE port 0 tunnel ID 1 with post display clearing of relevant statistics:
switch:admin> portshow ficon ge0 1 -epcb -clear
To display a list of discovered devices and selected path and status information on each. Get the
adrs from this display for the next command:
switch:admin> portshow ficon ge0 all -fdcb
This command displays details on the FDCB specified in the adrs argument which was derived from
the previous example:
switch:admin> portshow ficon ge0 all -fdcb 10008000