Brocade Fabric OS Command Reference Guide v6.1.0 (53-1000599-02, June 2008)

532 Fabric OS Command Reference
53-1000599-02
portStatsShow
2
er_other_discard The number of other discards (platform- and port-specific).
er_zone_discard The number of class 3 frames discarded due to zone mismatch.
er_type1_miss The number of frames with FTB type 1 miss.
er_type2_miss The number of frames with FTB type 2 miss.
er_type6_miss The number of frames with FTB type 6 miss.
er_zone_miss The number of frames with hard zoning miss.
er_lun_zone_miss The number of frames with LUN zoning miss.
er_crc_good_eof The number of CRC errors with good EOF (platform- and port-specific).
er_inv_arb The number of invalid ARBs.
open The number of times the FL_Port entered OPEN state.
transfer The number of times the FL_Port entered TRANSFER state.
opened The number of times the FL_Port entered OPENED state.
starve_stop The number of loop tenancies stopped due to starvation.
fl_tenancy The number of times FL_Port had loop tenancy.
nl_tenancy The number of times NL_Port had loop tenancy.
zero_tenancy The number of times zero tenancy occurred.
Note The execution of this command is subject to Admin Domain restrictions that may be in place. Refer
to chapter 1, "Understanding Admin Domain Restrictions" and Appendix A, "Command Availability"
for details.
Operands This command has the following operands:
slotnumber For bladed systems only, specifies the slot number of the port to be displayed,
followed by a slash (/).
[ge]portnumber Specifies a port number to be configured, relative to its slot for bladed
systems. Specify the optional ge option to display the GbE port hardware
statistics. Use switchShow to display a list of valid ports.
ge Displays the GbE statistics.
ip Displays all the GbE port statistics related to IP addresses that are on (not
zero).
ipaddress Optionally specify an IP address to display statistics only for the specified IP
address.
fcip Displays the GbE statistics on all FCIP tunnels.
tunnelnumber Optionally specify a tunnel ID to display statistics only for the specified FCIP
tunnel.
Examples To display the basic set of statistics for port 1/0 on a DCX backbone:
switch:admin> portstatsshow 13
stat_wtx 1979747673 4-byte words transmitted
stat_wrx 618367 4-byte words received
stat_ftx 1958745847 Frames transmitted