Brocade Fabric OS Command Reference Guide v6.1.0 (53-1000599-02, June 2008)

Fabric OS Command Reference 593
53-1000599-02
setModem
2
In the recommended configuration, a separate modem is connected to each modem port of CP0
and CP1. These modems connect to the telephone outlet through an RJ-11 Y-adapter and standard
telephone wire (see Figure ) is attached to the wall outlet, as shown in the figure.
During an incoming call, both modems ring and the one connected to the active CP answers the
call first. If for any reason the active modem fails to answer, the caller is logged in to the standby
CP.
Note The execution of this command is subject to Admin Domain restrictions that may be in place.Refer
to chapter 1, "Understanding Admin Domain Restrictions" and Appendix A, "Command Availability"
for details.
This command is not supported on the Brocade DCX backbone.
Operands The optional operands are as follows:
-e Enables modem dial-in.
-d Disables modem dial-in.
Examples To disable modem dial-in to a CP:
switch:admin> setmodem -d
disabling modem, please wait, this can take a couple of minutes...
modem disabled
See Also none