HP StorageWorks Fabric OS 6.2 administrator guide (5697-0016, May 2009)

Fabric OS 6.2 administrator guide 169
5. Respond to the prompts as follows:
6. At the Do you want to continue [y/n] prompt, enter y.
7. Wait for the configuration to be restored.
The following example shows configDownload run on a switch without Admin Domains:
switch:admin> configdownload
Protocol (scp, ftp, local) [ftp]:
Server Name or IP Address [host]: 10.1.2.3
User Name [user]: joeUser
File Name [config.txt]:
Section (all|chassis|FID# [all]): all
*** CAUTION ***
This command is used to download a backed-up configuration
for a specific switch. If using a file from a different
switch, this file's configuration settings will override
any current switch settings. Downloading a configuration
file, which was uploaded from a different type of switch,
may cause this switch to fail. A switch reboot might be
required for some parameter changes to take effect.
configDownload operation may take several minutes
to complete for large files.
Do you want to continue [y/n]: y
Password: <hidden>
configDownload complete.
Protocol (scp or
ftp)
If your site requires the use of Secure Copy, specify scp. Otherwise, specify ftp.
Server Name or IP
Address
Enter the name or IP address of the server where the file is stored; for example,
192.1.2.3. You can enter a server name if DNS is enabled.
User name Enter the user name of your account on the server; for example, JohnDoe.
File name Specify the full path name of the backup file; for example,
/pub/configurations/config.txt
Section Specify -all for the chassis, switch, or Logical Switches, or specify -chassis for
the chassis only, -fid to download a switch configuration data to a Logical Switch
specified by its fabric ID. This parameter is valid only in a Virtual Fabric environment
and requires chassis permissions.
Password Enter your account password for the server. Note that this is a required field even if
you are logged in as an anonymous user; in such cases, the value may be ignored
by the FTP service.