HP StorageWorks Fabric OS 6.2 administrator guide (5697-0016, May 2009)

Fabric OS 6.2 administrator guide 329
switch:admin> cfgenable iscsi_cfg001
You are about to enable a new zoning configuration.
This action will replace the old zoning configuration with the
current configuration selected.
Do you want to enable 'iscsi_cfg001' configuration (yes, y, no, n): [no]
y
zone config "iscsi_cfg001" is in effect
Updating flash ...
switch:admin>
iSNS client service configuration
The internet storage name service (iSNS) server facilitates the automatic discovery and manages access
control of iSCSI VTs on a TCP/IP network.
iSNS clients initiate transactions with iSNS servers using the iSNS protocol, register available iSCSI VTs,
download information about other registered clients (such as iSCSI initiators), and receive notification of
events that occur in the DDs.
Figure 41 iSCSI network with iSNS server and clients
NOTE: Fabric OS supports only Microsoft iSNS Server 3.0 and later.
Displaying iSNS client service status
1. Connect and log in to the switch.
2. Enter the fosConfig command to show the current Fabric OS configuration.
switch:admin> fosconfig --show
FC Routing service:disabled
iSCSI service:enabled
iSNS Client service:disabled
Enabling the iSNS client service
This section explains how to enable the iSNS client service and configure the iSNS server IP address.
Fabric OS supports one iSNS server connection.
iS NS clie nt
FC
target 1
iS NS
server
iS CSI
VT 1
iS CSI initiator
iS C S I gateway s ervice
iS NS clie nt
IP N etwork
FC SAN