HP StorageWorks Fabric OS 6.2 administrator guide (5697-0016, May 2009)

380 Using the FC-FC routing service
3. Determine whether to set up FC Router port cost operations and/or ISL or EX-Port trunking.
These options include FC Router port cost operations and setting up either ISL or EX_Port trunking. For
information about using FCR Router Port Cost operations, see ”FC Router port cost configuration” on
page 383 and for information on trunking setup, see ”Configuring EX_Port frame trunking” on
page 385.
4. Enter the portEnable command to enable the ports that you disabled in step 1. You can now
physically attach ISLs from the Fibre Channel Router to the edge fabric.
switch:admin> portenable 7/10
5. Enter the portCfgShow command to view ports that are persistently disabled.
switch:admin> portcfgshow 7/10
Area Number: 74
Speed Level: AUTO
Trunk Port OFF
Long Distance OFF
VC Link Init OFF
Locked L_Port OFF
Locked G_Port OFF
Disabled E_Port OFF
ISL R_RDY Mode OFF
RSCN Suppressed OFF
Persistent Disable OFF
NPIV capability ON
EX Port ON
Mirror Port ON
FC Fastwrite ON
6. After identifying such ports, enter the portCfgPersistentEnable command to enable the port,
and then the portCfgShow command to verify that the port is enabled.
switch:admin> portcfgpersistentenable 7/10
switch:admin> portcfgshow 7/10
Area Number: 74
Speed Level: AUTO
Trunk Port OFF
Long Distance OFF
VC Link Init OFF
Locked L_Port OFF
Locked G_Port OFF
Disabled E_Port OFF
ISL R_RDY Mode OFF
RSCN Suppressed OFF
Persistent Disable OFF
NPIV capability ON
EX Port ON
Mirror Port ON
FC Fastwrite ON
7. Enter either the portCfgEXPort or portShow command to verify that each port is configured
correctly:
switch:admin> portcfgexport 7/10