HP SureStore 220mx Optical Jukebox User's Guide

Chapter 1 1-5
Setting up the Jukebox
Identifying Rear Panel Features
Setting Up the Jukebox
The numbers below correspond to the numbers in Figure 1-1 on the
previous page.
1Power
receptacle
Used to connect the power cord to the
jukebox.
2 Standby/on
switch
The ON position appplies power to the
robotics and electronics in the jukebox.
The STANDBY position removes power
from the robotics and electronics of the
jukebox but power remains ON inside
the power supply enclosure on the rear
of the jukebox.
To remove power completely from the
jukebox, you must remove the power
cable either from the rear input on the
jukebox or at the wall/floor electrical
outlet.
3 SCSI ports Two 68-pin high-density connectors
that allow connection to either a
single-ended or low-voltage differential
SCSI bus. A terminator must be
plugged into one of these connectors
when the jukebox is the last physical
device on a SCSI bus. The terminator
shipped with the jukebox is a
single-ended / low-voltage differential
terminator.
For the most flexible configuration, use
a self-configuring single-ended /
low-voltage differential terminator
(SE/LVD) even though the jukebox is
may be originally configured onto a
low-voltage differential bus.