HP SureStore 220mx Optical Jukebox User's Guide

1-14 Chapter 1
Setting up the Jukebox
Connecting Power, Adjusting IDs, and Turning the Jukebox On
Connecting Power, Adjusting IDs, and
Turning the Jukebox On
NOTE If you are changing SCSI IDs on the host bus adapter to avoid conflicts,
change the IDs before turning host power OFF.
If you are changing IDs on one (or two) of this jukebox to avoid conflicts,
the following steps include this option.
1. Ensure that your host computer is OFF and the jukebox standby/on
switch is in the STANDBY position.
2. Plug the socket end of the power cord into the power port on the rear
of the jukebox (see “1” on Figure 1-1). Use the power cord supplied
with the jukebox.
3. Plug the other end of the power cord into a grounded electrical outlet.
CAUTION Placing the standby/on switch to STANDBY does not remove all power
from the jukebox. To remove all power (including primary power) you
must pull the jukebox power plug from the wall/floor receptacle.
4. Press the jukebox standby/on switch to ON.
NOTE If you are connecting two libraries, place both libraries to ON.
The remaining steps apply to both libraries.
5. Initially,
TESTING appears in the display window on the front of the
jukebox. Once the poweron test completes (approximately 1.5
minutes),
READY displays.
NOTE If FAIL 1 displays, the poweron test was not successful. Feel under the
chassis at the location shown in Figure 1-3 to ensure that the shipping
screw was removed. If the shipping screw was removed, refer to
“Troubleshooting” in Chapter 3.