HP SureStore 220mx Optical Jukebox User's Guide

1-16 Chapter 1
Setting up the Jukebox
Moving or Shipping the Jukebox
Moving or Shipping the Jukebox
To move the jukebox a short distance, such as to another office or to
another floor in your building, refer to “Moving the Jukebox a Short
Distance”. To ship the jukebox to another location, refer to “Shipping the
Jukebox”.
Moving the Jukebox a Short Distance
1. Unmount any optical disk surfaces in the jukebox if necessary.
See your computer operating system, or software application
documentation for instructions on how to unmount optical disks.
2. Ensure that there are no disks in the drives.
Eject any disks as necessary. Refer to your jukebox application
software documentation. If you will be manually ejecting disks, refer
to “Ejecting a Disk Cartridge From the Jukebox” on page 3-10.
CAUTION Failure to eject a disk from the optical drive prior to moving the jukebox
could result in damage to the optical drive mechanism.
CAUTION Do not turn off power to the jukebox until you are sure the SCSI bus is
inactive. Removing power from a SCSI peripheral when the bus is active
can result in data loss and/or indeterminate bus states. Check your host
system manuals for information about checking the SCSI bus status.
If your computer is connected to a LAN, ensure that other users on the
LAN are not accessing the jukebox.
3. Switch the jukebox standby/on switch to STANDBY (see “2” on
Figure 1-1).
4. Remove the power cord from the wall/floor receptacle and the SCSI
cable connections from the rear of the jukebox.
5. Carefully move the jukebox to its new destination. If the jukebox
contains disks, do not tip the jukebox or lay it on its side.
6. Set up the jukebox at its new location, following the procedures in the
beginning of this chapter.