HP SureStore 220mx Optical Jukebox User's Guide

3-12 Chapter 3
Operating the Jukebox
Using the Front Panel Features
NOTE Don’t forget your security code. If you forget it, only your service
representative can reset the security code to the factory setting so you
can set a new code.
Start with
READY or SECURE in the display.
1. Press
NEXT until CONF * displays
2. Press
ENTER. CONF 0 and a flashing 0 displays.
3. Press
NEXT until CONF 17 displays.
NOTE Starting from when you press ENTER in the next step, you are prompted
to enter the current security code.
4. Press
ENTER. CODE 1 and a flashing 0 displays.
5. Press
NEXT until the first number of your current security code
displays.
6. Press ENTER. CODE 2 and a flashing 0 displays.
7. Press
NEXT until the second number of your current security code
displays.
8. Press ENTER. CODE 3 and a flashing 0 displays.
9. Press
NEXT until the third number of your current security code
displays.
10.Press ENTER.
NOTE If you entered an incorrect code, NO CONFIG displays briefly and then
CONF 17 displays. Repeat steps 4-10 again and enter the correct current
code.
After entering the current security code in the previous steps, you are
prompted to enter a new three-digit security code.
11.Press
ENTER. NEW 1 and a flashing digit displays (the previous code
1).
12.Press NEXT until the first number you want in your security code
displays
13. Press ENTER. NEW 2 and a flashing digit displays (the previous code