HP SureStore 220mx Optical Jukebox User's Guide

Chapter 3 3-23
Operating the Jukebox
Changing SCSI IDs
Operating the Jukebox
assigned one ID and one ID is assigned to each disk drive.
The default SCSI IDs are as follows
• jukebox controller = 3
disk drive 1 (lower drive) = 4
disk drive 2 (upper drive in a two-drive model) = 5
If you are already using one of these IDs for your host bus adapter or
another SCSI peripheral device, follow the directions in one of the next
two sections to change either the jukebox controller or a drive ID.
Changing the Jukebox Controller ID
Start with READY or SECURE in the display.
1. Press
NEXT until SCSI ID * displays.
2. Press
ENTER. AC ID * displays. (“AC” is the “jukebox controller.”)
3. Press
ENTER. AC ID 3 displays.
4. Press
NEXT or PREV until the ID you want displays.
5. Press
ENTER. SET # (# is a number from 0-7) displays briefly and then
A
C ID * displays again. The ID you chose is now set.
6. Press
CANCEL two times to return to the READY state.
NOTE CONFLICT displays if you attempt to set the jukebox controller and a
drive to the same ID. Repeat the procedure and reset one of the IDs to
another, non-conflicting ID.
NOTE After you change an ID you may have to restart your host computer for
the new ID to be recognized.