HP StorageWorks All-in-One Storage System user guide (440583-005, February 2008)

See “Powering on the server” on page 22 and “Using
the direct attach method” on page 23.
3. Connect cables; (optional) connect
a keyboard, mouse, and monitor;
power on server; and log on to the
server.
See “Accessing the All-in-One Management
Console” on page 23.
4. Access the All-in-One Management
Console.
See “Server configuration steps” on page 30.
5. Complete the storage system
configuration worksheet.
See “Running the Rapid Startup Wizard” on page 32.6. Run Rapid Startup Wizard.
See “Completing system configuration” on page 32.7. Complete system configuration.
See “Installing the All-in-One Storage Manager
Agent” on page 33.
8. Install the All-in-One Storage
Manager Agent on network application
servers.
See “Configuring storage server for Web access
(optional)” on page 181.
9. Configure storage system for Web
access, if necessary.
Installing the server
To install your HP StorageWorks All-in-One Storage System, follow the instructions in the sections
below:
• Locating and writing down the serial number
• Checking kit contents
• Powering on the server
Locating and writing down the serial number
Before completing the installation portion of this guide, locate and write down the storage system's
serial number, which you may need to access the All-in-One Storage Manager (ASM) later on during
the set up process.
The All-in-One Storage System serial number is located in three places:
• Top of the server
• Back of the server
• Inside the server shipping box
Checking kit contents
Remove the contents, making sure you have all the components listed below. If components are missing,
contact HP technical support.
• HP StorageWorks All-in-One Storage System (with operating system preloaded)
• Power cord(s)
• Product Documentation and Safety and Disposal Documentation CD
• HP StorageWorks All-in-One Storage System Recovery DVD
• End User License Agreement
• Certificate of Authenticity Card
All-in-One Storage System 21