HP StorageWorks Command View XP Command Line Interface (CLI) reference guide (B9357-96161, January 2006)

Command View XP Command Line Interface (CLI) reference guide 203
Error codes
Table 4 XP48/XP512 error codes
Error code Description
1000 The request of Host Mode (0xN1, 0xN2) is not matched to both of clusters ports
value. Both of them must be the same.
1002 CA and/or BC volumes were tried to set the command Device.
1003 Your request was that the path to LDEV would be configured again. The path was set
already from that port.
1004 Your request was that the single combination of Port, SCSI ID, and LUN would be
configured for more than one volume.
1005 You tried to set the Path to the non-first LDEV at LUSE. You have to set the path to the
first LDEV number at LUSE.
1007 Your request of configuration change for the port was rejected, because either you
tried to delete the only single path to the CA and/or BC volume OR some host has
issued I/Os to the port.
1008 You tried to set volume that did not have any path as Command Device. Or you tried
to delete the only single path to the Command Device.
1009 Your request of LUSE is not any correct emulation type of open volume.
1010 Your request was to combine some LDEVs as LUSE, however that had been defined
as LUSE before your request.
1011 You tried to set LDEVs of LUSE, but they were over the limitation of CU boundary.
1012 Your request of path definition of LUSE was already defined.
1013 Your request of LDEVs of LUSE had different type of emulation type.
1014 Your request of path definition of expanded volume (by LUSE) was rejected. The LUSE
volume might not have any path or might lose any path.
1015 Your request of cancellation of LUSE configuration had still paths.
1016 You tried to combine CVS volume as LUSE.
1017 Your request to the DKC serial number was not existing.
1018 Your request to the port was not existing. Or your request to the port might be
miss-matched such as the request to the Mainframe port.
1019 Your request to the SCSI ID was incorrect.
1020 Your request to the LUN was incorrect.
1021 Your request to the volume (CU#:LDEV#) was not existing. Or your request was to the
Mainframe volume.
1022 Your request to the Host Mode was incorrect.
1023 Your request to the FC address was incorrect.
1024 Your request to the FC topology was incorrect.
1025 Your request to the path was not existing.
1026 Your request to the LDEVs were not continuous number of LDEVs for the LUSE.
1027 Your request to the Command Device was incorrect.