HP StorageWorks Command View XP Command Line Interface (CLI) reference guide (B9357-96161, January 2006)

Command View XP Command Line Interface (CLI) reference guide 207
1101 CVS operation (Deinstall CV) was demanded from non-mounted volume.
1102 LDEV you tried to delete is the only Normal LDEV in the Parity Group. You cannot
delete it by VSC Operation.
1103 The specific parity group is not configured in the Array.
1104 The SubSystem ID (SSID) can be set only by performing VSC operation.
1105 For the VSC operation, LDEV IDs assigned exceeds the number which can be set.
1106 The Path setting request was carried out to the Reserve-Volume for Auto LUN. Correct
the contents of specification and send a composition information setting demand
again.
1107 The Reserve-Volume setting request for Auto LUN was carried out to the volume to
which the Path is set. Correct the contents of specification and send a composition
information setting demand again.
1108 The setting request of the Command -Device was carried out to the Reserve-Volume
for Auto LUN. Correct the contents of specification and send a composition
information setting demand again.
1110 Nickname is having an invalid character in the LUN Security Configuration Change
request.
1111 Nickname is not specified in the LUN Security configuration change request.
1112 For the Auto LUN related configuration change request, the LDEV is set to migrate to
the same RAID group.
1201 CHA High-Speed Mode specification was carried out. There is the Path which cannot
set High-Speed mode into the specified Port. The parameter is changed into the path
in which a High-Speed Mode setup is possible, and send a composition information
setting demand again.
1202 CHA High-Speed Mode specification was carried out. There is the Host mode which
cannot set High-Speed mode into the specified Port. The parameter is changed into
the Host-Mode in which a High-Speed Mode setup is possible, and send a
composition information setting demand again.
1203 CHA High-Speed Mode specification was carried out. There is the Fibre Address
which cannot set High-Speed mode into the specified Port. The parameter is changed
into the Fibre address in which a High-Speed Mode setup is possible, and send a
composition information setting demand again.
1204 CHA High-Speed Mode specification was carried out. There is the Topology which
cannot set High-Speed mode into the specified Port. The parameter is changed into
the Topology in which a High-Speed Mode setup is possible, and send a
composition information setting demand again.
1205 CHA High-Speed Mode specification was carried out. There is the Fibre PCB which
cannot set High-Speed mode into the specified Port. The parameter is changed into
the Fibre PCB in which a High-Speed Mode setup is possible, and send a
composition information setting demand again.
1206 It cannot set by request because there is the CHA which is not set mode. Set the
mode of the CHA, and send a composition information setting demand again.
1207 In the volume migration request, there are different points between Source volume
and Target volume (ex: Track format, Number of Cylinder, etc.). Set same formatted
volumes for Source and Target.
Table 4 XP48/XP512 error codes (continued)
Error code Description