HP StorageWorks Command View XP Command Line Interface (CLI) reference guide (B9357-96161, January 2006)

Command View XP Command Line Interface (CLI) reference guide 211
1268 When change request to the configuration data of port control, both of the threshold
level for Total priority Port and priority port are set at same time. Change Request
and re-send Set-Request.
1269 The priority mode change failed as Host I/Os are in progress.
1270 WWN is not specified in the configuration change request of PPC.
1273 Specified WWN is not configured in the array.
1280 Parity Group which is not configured as On-Demand has been specified.
1282 You cannot combine On-Demand, LUN Mgmt Operation and Cache LUN operation
in a single configuration change request.
1283 Specified Parity Group is reserved for On-Demand operations.
1290 You are trying to install a Temporary key within 180 days after the expiry of the last
Temporary Key that was installed or trying to install a Temporary Key when already
a Temporary Key is installed.
1291 Capacity of License Key that you are trying to install is insufficient. Please get License
Key that is of adequate capacity.
1292 Permanent License Key that you are trying to install is not correct or is of inadequate
capacity.
1293 You are trying to install a temporary or emergency License Key when you already
have a Permanent Key installed for the software.
1294 The Uninstall Operation of the License Key for software is not done properly. Kindly
try to Uninstall it again.
1295 License Key code is incorrect. Please install the correct License Key.
1296 The Licensed Software that is needed before the particular software license that you
are trying to install, is not installed.
1297 The License Key is not installed for the particular product. Please get the license key
by contacting the HP Product Support.
1298 Both Install and Uninstall commands cannot be executed in same SET operation.
Kindly send these commands separately.
1299 Multiple Uninstall requests were sent in a single SET Request.
2000 Your request was rejected because somebody operated to the RC.
2001 SetRequests of configuration or GetRequest were issued at the initial state. At that
time R.C. did not have any MIB information to the request. This message may occur
at the first operation without Refresh Request.
2002 Your request was failed, because of connection issue between R.C. and SVP. Or you
request too early timing, SNMP agent did not start yet.
2003 Request to read information from SVP failed. SVP may be running low on resources.
Please have HP representative verify proper SVP RAM configuration and verify that
no unsupported applications are running on the SVP.
2004 Mandatory files (Windows DLL/EXE files etc.) could not be loaded for the SNMP
operation.
2005 Minimum capacity of memory was not assigned for the operation.
Table 4 XP48/XP512 error codes (continued)
Error code Description