HP StorageWorks Command View XP Command Line Interface (CLI) reference guide (B9357-96161, January 2006)

220 Error messages
31129 For WWN related configuration change requests (add/change), the maximum
number that can be set for a port is already reached (range is 0 - 254). Please check
the settings.
31130 Configuration change request contains number of host mode settings which exceeds
the maximum number if host group IDs in the port. Please check the setting.
31131 Configuration change requests contains number of path settings which exceeds the
maximum number which can be set in the port.
31132 When the PORT information (Fibre Address/Fibre Topology/Channel Speed) is set,
multiple instructions on change are set to the same PORT. Please check the setting.
31133 When the CHA high-speed mode is set, multiple instructions on change are set to the
same PORT. Please check the setting.
31134 Configuration change request contains number greater than the maximum number of
LUSE (MAX.4096). Please check the setting.
31137 The Port Group settings needs to be canceled/deleted before performing this
operation.
31138 DKC is in the BUSY status. Please wait for a while and resume the operation.
31139 The LDEV has LDEV Security set. Please switch off the LDEV Security before
performing the operation.
31140 An internal CV Server error occurred. Please report this to the HP Product Support.
31141 VSC operation involves LDEVs which are part of LUSE. Please disperse the specific
LDEVs and perform the operation again.
31198 Though the CHA high-speed mode is specified, the high-speed mode cannot be set
to some of the specified paths. (CHA speeds are not the same.) Please check the
setting.
31200 Though the CHA high-speed mode is specified, the high-speed mode cannot be set
to some of the specified ports. (Fibre Addresses are not the same). Please check the
setting.
31201 Though the CHA high-speed mode is specified, the high-speed mode cannot be set
to some of the topologies in the specified port. (FC-AL specifications are not the
same). Please check the setting.
31347 Since the port to which the path is tried to be set is the port for CA, it cannot be
used. Change the attribute of the target port to TarGet or RCU TarGet in order to
enable the path setting.
31348 Some ports to which the CHA high-speed mode is set have the different attributes.
When setting the CHA high-speed mode, set the same port attributes.
31349 Since the port for which you had performed the configuration change request has the
logical paths for CA, it cannot be changed. Delete the logical paths, and re-issue the
request for configuration change.
31350 Since the port for which you had performed the configuration change request has the
S-VOL logical paths, it cannot be set. You need to delete and set the S-VOL logical
paths which is set to the RCU TarGet port. Re-issue the request for configuration
change.
31351 Since the port for which you had performed the configuration change request is the
Initiator Port of CA, it cannot be changed. Please change the port attribute. (Change
to TarGet or RCU TarGet attribute.)
Table 5 XP128/XP1024/XP10000/XP12000 error codes (continued)
Error code Description