Brocade Fabric OS Command Reference Manual Supporting Fabric OS v7.0.0 (April 2011)
Fabric OS Command Reference xxvii
53-1002147-01
- portCfgAutoDisable --remove - Remove specified triggers.
- portCfgAutoDisable --addall - Add all triggers.
- portCfgAutoDisable --removeall - Remove all triggers.
- portCfgAutoDisable--addexcept - Add all triggers except provided options.
- portCfgAutoDisable --show - Show configured/added options.
• portCfgShow - displays the configured values .
• portCfgDefault - Enhanced to reset port auto disable flag to a disabled state.
Port Mirroring
Port mirroring is not supported over FCIP links (VE tunnels) or for Condor 3 FC ports that have
Encryption or Compression enabled.
• portMirror
• portCfg mirrorport
Security
• Ipfilter New enhancements:
- ipfilter --clrcounters
- ipfilter --showcounters
- Permit and deny actions are not allowed on ports 1024. and above.
• aaaConfig - New -nologout option protects existing sessions from termination when changing
protocols.
• secPolicyCreate - DCC Policy lockdown does not work in switch disabled state.
• secStatsShow - - Updated list of valid security policies.
• sshUtil - Modified to generate authentication keys for a specified use
SNMP
• snmpConfig enhancements:
- Support for new SW traps: swStateChange, swMovePort, and swBrcdGenericTrap
- Ability to blocks or unblocks access to SNMPv1 snmpConfig --enable | --disable snmpv1
• snmpTraps - Enhanced to block a port from receiving traps.
- snmptraps --block | --unblock -port [slot]port | ALL
TI- Zones - enhanced error detection
New option to zone command generates a report of potential routing problems in the local Domain.
zone --showTIerror
DEPRECATED COMMANDS
Information that was removed or deprecated since this document was last released:
• cfgSaveActiveToDefined
• cfgMcdtMode
• chassisConfig
• fabPortShow (Brocade internal use only)