HP StorageWorks Fabric OS 5.x Fabric Watch Administrator Guide (AA-RVJ0B-TE, September 2005)

Fabric OS 5.x Fabric Watch administrator guide 31
• Receive alarm notification via SNMP traps.
• View and configure the mail database.
NOTE: The following instructions apply to the AdvantNet MIB browser. There may be some variation in
the procedures when other MIB browsers are used.
To configure Fabric Watch with an SNMP-based enterprise manager, begin by connecting to the switch
using a MIB browser:
1. Open a MIB browser.
2. If not already done, load the appropriate MIB files. First load the Brocade common MIB file, followed
by the Brocade software MIB file. The system should respond with a screen similar to the following:
The MIB browser has populated the left side of the screen with a MIB tree that you can navigate.
3. Begin a telnet session with the switch and issue the agtCfgSet command.
Information on the agtCfgSet command may be found in the
HP StorageWorks Fabric OS 5.x command
reference guide
.
4. Enter the IP address for the switch into the Host field. Enter the community into the Community field.
Enter the write community into the Write Community field, if you want to perform set operations.