HP StorageWorks HSG80 ACS Solution Software V8.8 for IBM AIX Installation and Configuration Guide (AA-RV1HA-TE, March 2005)

Installing and Configuring HSG Agent
130 HSG80 ACS Solution Software V8.8 for IBM AIX Installation and Configuration Guide
Configuration Options for the SWCC Agent
After the Agent has been installed, it is possible to configure the SWCC Agent to
change some of its operating settings or to add a new Client, subsystem, or email
address. The further configuration options can be done from one of two places:
■ The /usr/stgwks2/config.sh script
■ SMIT (under Applications->Compaq SWCC Agent Configuration)
Note: If any change is made the SWCC Agent configuration, the Agent has to be
stopped and restarted for the change to take effect.
All these options should be available from both places, except for password
changes, which have to done from the
config.sh script.
■ Change Enterprise OID—Change the Enterprise Object ID that is used when
the Agent sends out SNMP traps.
■ Change Password—Change the password that is used for authentication in the
Client. You can only change the password using the
/usr/stgwks2/config.sh script.
■ Start/Stop Agent—Start or stop the Agent process
■ Toggle Agent Startup on Boot—Set up whether the Agent starts automatically
when the system is booted. Automatic start is done through an entry placed in
the
/etc/inittab file. When Agent startup on boot is enabled, the setting in
/etc/inittab file is set to “once”. When Agent startup on boot is disabled, it
is set to “off”.
■ Add Client—Add another Client PC. There are different levels of access
privilege that can be set and different methods of notification that can be set
for each Client. Here is a brief description of each:
The Access Privilege options are:
0—The Client can only view the main storage window; it cannot open a
system window for any of the RAID arrays on the host that you are currently
on
1—The Client can view the main storage window and any of the system
windows. However, this Client cannot do any configuration.
2—This Client can view any storage window and configure any RAID array
on the current host system