HP StorageWorks HSG80 ACS Solution Software V8.8 for Novell NetWare Installation and Configuration Guide (AA-RV1MA-TE, March 2005)

113HSG80 ACS Solution Software V8.8 for Novell NetWare Installation and Configuration Guide
5
FC Configuration Procedures
This chapter describes procedures to configure a subsystem that uses Fibre
Channel (FC) fabric topology. In fabric topology, the controller connects to its
hosts through switches.
The following information is included in this chapter:
■ "Establishing a Local Connection", page 114
■ "Setting Up a Single Controller", page 115
■ "Setting Up a Controller Pair", page 122
■ "Configuring Devices", page 130
■ "Configuring Storage Containers", page 131
■ "Assigning Unit Numbers and Unit Qualifiers", page 137
■ "Configuration Options", page 139
Use the command line interpreter (CLI) to configure the subsystem. This chapter
uses CLI to connect to the controller.
Note: These configuration procedures assume that controllers and cache modules are
installed in a fully functional and populated enclosure and that the PCMCIA cards are
installed.
To install a controller or cache module and the PCMCIA card, see the HP
StorageWorks HSG60 and HSG80 Array Controller and Array Controller
Software Maintenance and Service Guide.