HP StorageWorks HSG80 ACS Solution Software V8.8 for Novell NetWare Installation and Configuration Guide (AA-RV1MA-TE, March 2005)

Backing Up, Cloning, and Moving Data
159HSG80 ACS Solution Software V8.8 for Novell NetWare Installation and Configuration Guide
The following example shows the commands you would use to Clone storage unit
D6. The Clone command terminates after it creates storage unit D33, a Clone or
copy of D6.
HSG80 >run clone
Clone Local Program Invoked
NOTE: The number of existing storagesets plus the storagesets
added for the
cloned unit is limited. CLONE will fail if these limits are
exceeded. Refer to the User's Guide for further
information.
Units available for cloning:
7
8
9
6
Enter unit to clone ?6
Clone will create a new unit which is a copy of unit 6.
Enter the unit number which you want assigned to the new unit
?33
The new unit may be added using one of the following methods:
1. Clone will pause after all members have been copied. The
user must
then press RETURN to cause the new unit to be added.
2. After all members have been copied, the unit will be added
automatically.
Under which above method should the new unit be added [] ?1
Devices available for clone targets:
LOCAL DISK60200 (size=17773524)
LOCAL DISK30100 (size=17773524)
LOCAL DISK20400 (size=142264000)
Use available device DISK60200(size=17773524) for
member DISK30400(size=17769177) (y,n) [y] ?y
set M2 nopolicy
set M2 members=5
set M2 replace=DISK60200
Copy in progress for each new member. Please be patient...