Fabric OS Message Reference v6.4.0 (53-1001767-01, June 2010)

Fabric OS Message Reference 35
53-1001767-01
AG-1038
2
Recommended
Action
If the switchshow command on the connected fabric switch port displays 'Persistently disabled:
Area has been acquired', then check the cabling on the AG. All trunked ports in a single trunk
should belong to the same ASIC Port Group.
Severity INFO
AG-1038
Message <timestamp>, [AG-1038], <sequence-number>,, ERROR, <system-name>,Elara Ports
going to different fabrics, Check N Port <nport>.
Probable Cause Indicates a misconfiguration.
Recommended
Action
Connect all ports in the port group to the same fabric.
Severity ERROR
AG-1039
Message <timestamp>, [AG-1039], <sequence-number>,, INFO, <system-name>,F-Port <Port that
was reset> was reset because a WWN mapped device using it, through N-Port <Port
who's state change caused the reset>, went offline.
Probable Cause Indicates a port needed to be reset because an N-Port went offline and the changes need to be
propagated to all involved devices.
Recommended
Action
No action is required. This port-reset was not an error.
Severity INFO