Fabric OS Message Reference v6.4.0 (53-1001767-01, June 2010)

40 Fabric OS Message Reference
53-1001767-01
AUTH-1004
4
AUTH-1004
Message <timestamp>, [AUTH-1004], <sequence-number>,, ERROR, <system-name>, Failed to set
<data type> type to <setting value>.
Probable Cause Indicates that the authUtil command has failed to set the authentication configuration value. The
data type is either authentication type, DH group type, or policy type.
Recommended
Action
Retry the authUtil command.
Run the supportFtp command (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity ERROR
AUTH-1005
Message <timestamp>, [AUTH-1005], <sequence-number>,, ERROR, <system-name>,
Authentication file does not exist:
<error code>.
Probable Cause Indicates an authentication file corruption.
Recommended
Action
Run the firmwareDownload command to reinstall the firmware.
Run the supportFtp command (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity ERROR
AUTH-1006
Message <timestamp>, [AUTH-1006], <sequence-number>,, WARNING, <system-name>, Failed to
open authentication configuration file.
Probable Cause Indicates an internal problem with the Secure Fabric OS.
Recommended
Action
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable
and switchEnable commands.
If the message persists, run the supportFtp command (as needed) to set up automatic FTP
transfers; then run the supportSave command and contact your switch service provider.
Severity WARNING
AUTH-1007
Message <timestamp>, [AUTH-1007], <sequence-number>,, ERROR, <system-name>, The proposed
authentication protocols are not supported: port
<port number>.
Probable Cause Indicates that the proposed authentication protocol type or types are not supported by the local
specified port.