Fabric OS Message Reference v6.4.0 (53-1001767-01, June 2010)

236 Fabric OS Message Reference
53-1001767-01
FCR-1083
34
FCR-1083
Message <timestamp>, [FCR-1083], <sequence-number>,, WARNING, <system-name>, The resume
message is rejected by the domain <Domain>.
Probable Cause Indicates that during the Coordinated HotCode protocol, a switch in the fabric has rejected the
pause message which prevented the protocol from completing. Any data traffic disruption observed
during the firmware download may have been due to the rejected resume message.
Recommended
Action
No action is required.
Severity WARNING
FCR-1084
Message <timestamp>, [FCR-1084], <sequence-number>,, WARNING, <system-name>, The resume
retry count is exhausted for the domain <Domain>.
Probable Cause Indicates that during the Coordinated HotCode protocol, a switch in the fabric did not accept the
resume message which prevented the protocol from completing. Any data traffic disruption
observed during the firmware download may have been due to this issue.
Recommended
Action
No action is required.
Severity WARNING
FCR-1085
Message <timestamp>, [FCR-1085], <sequence-number>,, ERROR, <system-name>, HA sync lost
as remote CP does not support FCR based matrix.
Probable Cause Indicates that the remote control processor (CP) has earlier firmware, which does not support the
FCR- based matrix while the local CP has the feature enabled. This is causing the loss of the
high-availability (HA) synchronization.
Recommended
Action
Disable FCR-based matrix or upgrade the remote CP.
Severity ERROR
FCR-1086
Message <timestamp>, [FCR-1086], <sequence-number>,, ERROR, <system-name>, HA sync lost
as remote CP does not support Condor2 based EX_ports.
Probable Cause Indicates that the remote control processor (CP) has older firmware, which does not support
Condor-based EX_ port. This is causing the loss of the high-availability (HA) synchronization.