Fabric OS Message Reference v6.4.0 (53-1001767-01, June 2010)

Fabric OS Message Reference 267
53-1001767-01
FICU-1007
36
Recommended
Action
Check if the FICON channel corresponding to the PID in the message is functioning correctly.
Severity WARNING
FICU-1007
Message <timestamp>, [FICU-1007], <sequence-number>,, WARNING, <system-name>, <function
name>: Failed to allocate memory while performing <message>.
Probable Cause Indicates that memory resources are low. This might be a transient problem.
Recommended
Action
If the message persists, check the memory usage on the switch, using the memShow command.
If the message persists, run the supportFtp command (as needed) to set up automatic FTP
transfers; then run the supportSave command and contact your switch service provider.
Severity WARNING
FICU-1008
Message <timestamp>, [FICU-1008], <sequence-number>,, WARNING, <system-name>, FMS mode
has been enabled. Ports:<port numbers> have been disabled due to port address
conflict.
Probable Cause Indicates that the specified ports were disabled when Fibre Connectivity (FICON) Management
Server mode (fmsMode) was enabled. This is due to a port address conflict or the port address
being reserved for the CUP management port.
Recommended
Action
No action is required.
Severity WARNING
FICU-1009
Message <timestamp>, [FICU-1009], <sequence-number>,, WARNING, <system-name>, FMS Mode
enable failed due to insufficient frame filtering resources on some ports.
Probable Cause Indicates that the frame filtering resources required to enable Fibre Connectivity (FICON)
Management Server mode (fmsMode) were not available on some of the ports.
Recommended
Action
Use the perfDelFilterMonitor command to delete the filter-based performance monitors used on all
ports to free up the resources.
Severity WARNING