Fabric OS Message Reference v6.4.0 (53-1001767-01, June 2010)

316 Fabric OS Message Reference
53-1001767-01
FW-1197
42
FW-1197
Message <timestamp>, [FW-1197], <sequence-number>,, INFO, <system-name>, <Port Name>,
<Label>, is below low boundary(High=<High value>, Low=<Low value>). Current value
is <Value> <Unit>.
Probable Cause Indicates that the number of link resets that the port experiences has fallen below the low
boundary. Link resets occur due to link timeout errors that indicate no frame activity at all.
Recommended
Action
Respond to this message as is appropriate to the particular policy of the end-user installation. A low
number of link resets means that the switch is functioning normally.
Severity INFO
FW-1198
Message <timestamp>, [FW-1198], <sequence-number>,, WARNING, <system-name>, <Port Name>,
<Label>, is above high boundary(High=<High value>, Low=<Low value>). Current value
is <Value> <Unit>.
Probable Cause Indicates that the number of link resets that the port experiences has risen above the high
boundary. Link resets occur due to link timeout errors that indicate no frame activity at all. Both
physical and hardware problems can cause link resets to increase.
Recommended
Action
Check both ends of your cable connection. Verify if the cable and small form-factor pluggables
(SFPs) are faulty.
Severity WARNING
FW-1199
Message <timestamp>, [FW-1199], <sequence-number>,, INFO, <system-name>, <Port Name>,
<Label>, is between high and low boundaries (High=<High value>, Low=<Low value>).
Current value is <Value> <Unit>.
Probable Cause Indicates that the number of link resets that the port experiences has changed from a value
outside of the acceptable range to a value within the acceptable range. Link resets occur due to
link timeout errors that indicate no frame activity at all. Both physical and hardware problems can
cause link resets to increase.
Recommended
Action
Respond to this message as is appropriate to the particular policy of the end-user installation.
Severity INFO
FW-1200
Message <timestamp>, [FW-1200], <sequence-number>,, INFO, <system-name>, <Port Name>,
<Label>, value has changed(High=<High value>, Low=<Low value>). Current value is
<Value> <Unit>.